By General Aviation News Staff · February 15, 2023 · Leave a Comment

The pilot stated that, during a cruise climb from the airport in Millville, Iowa, the Cessna 182’s engine made a “loud growling” noise and lost power. He turned the magnetos off when he saw smoke near the propeller and trimmed the airplane for a best glide airspeed.

He told investigators there was no suitable landing area in front of the airplane, but there was a road to the left of the airplane. During the approach to the road, he maneuvered below powerlines and avoided buildings before the airplane hit the road and a snowbank.

The airplane nosed over during the landing, resulting in substantial damage to the fuselage, right wing, and right-wing strut. The commercial pilot and a passenger received minor injuries. 

Post-accident examination of the airplane revealed a hole in the engine crankcase located between the Nos. 2 and 5 cylinders. The No. 2 cylinder connecting rod was protruding through the hole and exhibited scoring consistent with oil starvation.

The vacuum pump did not exhibit any mechanical anomalies and the inside of its vacuum tube did not contain oil. There was a relatively large amount of oil on the underside of the top engine cowling. There was no oil on the interior or exterior side of the bottom engine cowling. There was no oil on the engine firewall. There was oil on the underside of the fuselage extending aft of the engine crankcase breather tube to the empennage. There was oil around the crankcase nose seal consistent with a leak.

The inside of the crankcase breather tube, which alleviates normal crankcase pressure, was unobstructed and contained oil. The tube contained a whistle stop/vent located about three inches from the bottom of the tube, which was in accordance with its design. The oil breather tube whistle stop/hole was positioned aft and parallel to the airplane’s longitudinal axis. Examination of the breather tube showed dried and caked oil residue, which are signs of progressive leakage. Similar signatures were observed at the crankcase nose seal. These would have been apparent during routine maintenance and/or a preflight inspection.

Continental Service Bulletin (SB) M89-9, Excessive Crankcase Pressures, provides a troubleshooting test when excessive crankcase pressures are suspected. The SB notes: “Excessive crankcase pressure in flight can be induced by ram air entering through an improper fitting oil cap seal and/or defective crankshaft nose seal. If the problem occurs on turbocharged engines only at higher altitudes, then it is possible that the turbocharger is suspect.”

Probable Cause: The inadequate maintenance/inspection of the airplane, which resulted in a total loss of engine power due to oil starvation.

To download the final report. Click here. This will trigger a PDF download to your device.

This February 2021 accident report is provided by the National Transportation Safety Board. Published as an educational tool, it is intended to help pilots learn from the misfortunes of others.

Join 110,000 readers each month and get the latest news and entertainment from the world of general aviation direct to your inbox, daily. Sign up here.

Your email address will not be published. Required fields are marked *

Save my name, email, and website in this browser for the next time I comment.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

© 2023 Flyer Media, Inc. All rights reserved. Privacy Policy